• NIke KD
  • KD VII
  • Nike Hyperrev
  • Air Max 90
  • Air Max Shoes Sale
  • Nike Free Shoes
  • Nike Free Run 2
  • lebron 12 shoes
  • cheap kobe shoes
  • Lebron 12
  • Lebron Jerseys For Sale
  • Cheap Kobe Jerseys
  • Ugg Store
  • KD Jersey
  • Jeremy Scott Adidas
  • Adidas Wings
  • Kobe Bryant Shoes
  • Porsche Design Adidas
  • Cheap Kobe Shoes
  • KD 6
  • Kevin Durant Shoes
  • Adidas Porsche Shoes
  • Cheap Lebron James Shoes
  • Kevin Durant Shoes
  • Herve Leger Outlet
  • Lebron James Shoes
  • Adidas Porsche Design Bounce
  • Nike Lebron Shoes
  • Lebron 11
  • Coach Outlet
  • nba jerseys for sale
  • louis vuitton bags
  • Kobe 9
  • Air Jordan 29
  • Nike Lebron Shoes
  • Nike Kobe Shoes
  • Kobe Shoes
  • Cheap Kobe Shoes
  • Cheap KD Shoes
  • KD 6
  • Utah Jazz Jerseys
  • Philadelphia 76ers Jerseys
  • kd 6
  • kd 7
  • kobe 9
  • Home >> Pic Show
    Pic Show class
    Pic Show
    53416U M
    NO. 20130731
    Standard£º
    SKF,FAG, INA,TIMKEN, NSK, NTN, NACHI, KOYO, IKO, THK, FYH,HIKI
    Remarks£º GCr15 --------ball bearing steels -----0Cr17Ni12Mo2------stainless steel ---AISI304---AISI316--AISI440
    Product Class£º Thrust Ball Bearings
    Product description

     Single-direction thrust ball bearing consists of one row of balls (with cage), a shaft washer (close fit with shaft) and a housing ring (loose fit with shaft and close fit with bore of bearing block). They can¡¯t carry radial loads but axial loads in one direction,because the axial loads are well distributed on each ball, the loading capacity is higher, but the temperature is high while working,and their limiting speed is lower.

    Thrust ball bearings can limit axial displacement of shafts or housings in one or twe directions, but not radial displacement. Therefore, the bearings are usually used with deep groove ball bearings.
    While mounting, the shaft and axis of housing bore must be concentric, otherwise bearing will be damaged in early period because of the stress concentration,and  0.5-1 mm radial clearance between outside diameter and bore of housing washer should be kept to avoid the influence.
    Steel pressed cages are usually used in thrust ball bearings; machined solid cages shoule be used when outer diameter is over 250mm.